![]() ![]() Click Sectioning Tools tab>Mode panel>Planes.Ģ. You can only manipulate one plane at a time (the current plane), but it is possible to link section planes together to form slices.ġ. This means that moving one gizmo affects the position of others. All gizmos share the same location/rotation. ![]() Section planes can be moved and rotated but cannot be scaled.īy default, when a section plane is made current, the move gizmo is used, unless you have already selected the rotate gizmo before activating the section plane. You can also manipulate the section box numerically. The section planes can be manipulated with the sectioning gizmos, available from the Sectioning Tools tab Transform panel. Optional: Click Sectioning Tools tab>Save panel>Save Viewpoint to save the current sectioned viewpoint. Drag the gizmo to position the current plane as needed.ģ. Default position is through the center of the visible area of the model. Īutodesk Navisworks opens the Sectioning Tools tab on the ribbon, and draws a section plane through the model in the Scene View. Click Viewpoint tab>Sectioning panel>Enable Sectioning. To use a plane to cross-section a 3D model for the first time:ġ. You can hide the visual plane representation by toggling the corresponding gizmo button. Visually, a section plane is represented by a light blue wireframe. Note: To save the settings for enabled section planes (alignment, position, rotation), you need to save the current viewpoint with sectioning enabled and in sectioning mode.īy default, a section plane is created within the view, and as close to the center of the view as possible. Afterwards, enabling a section plane restores the saved alignment, position, and rotation if it is available for the current viewpoint. When a section plane is first enabled, it is created with the default alignment and position. Selecting a plane as current automatically enables that plane if it was not already enabled. The current plane is the one that is rendered visibly in the Scene View. When a plane is ‘enabled’ it means that it affects (cuts through) the scene. To view cross-sectional cuts of your model, you can enable up to six section planes. As you move the box around, only the geometry within the defined section box is displayed in the Scene View. Section planes are stored inside viewpoints and so can also be used within viewpoint animations and object animations to show a dynamically sectioned model.īox mode enables you to focus your review on specific and limited areas of the model. By default section planes are created through the center of the visible area of the model. ![]() Planes mode allows you to make up to six sectional cuts in any plane while still being able to navigate around the scene, enabling you to see inside models without hiding any item. There are two sectioning modes available from the Sectioning Tools tab>Mode panel: Planes and Box. When the sectioning is turned on, the Sectioning Tools contextual tab is automatically displayed on the ribbon. You can turn sectioning on and off for the current viewpoint by clicking Viewpoint tab>Sectioning panel>Enable Sectioning. You can now directly manipulate position and rotation of section planes and section box with sectioning gizmos.Ī cross section is a cut-away view of a 3D object that enable you to see inside it. Autodesk Naviswork Manage 2011 enables you to turn on sectioning for the current viewpoint and to create cross sections of your model.įaster, easier, more intuitive sectioning. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |